Removal of weld seams on stainless steel, steel and aluminum

1. Pre-sand with coarse grinding grits (60-100 grits) depending on the thickness on the welding seam.

2. As quickly as the welding seam has just about been sanded to the level of the surface, change to a finer grit (120-180 grits). Perform by means of the sequence of ever finer grits until the requested finish is achieved. Don't skip grit levels. Get more details about go to this website

3. Use SCM belts to attain a decorative finish:
Use a 100/120 or maybe a 180/240 granulation SCM belt to attain a dull finish. Machine should be set to "3" on the RPM pre-set dial.
Use a 400 granulation SCM belt to achieve a brilliant finish. Machine need to be set to "6" around the RPM pre-set dial.

NOTE: Usually do not skip grit levels as this will leave an unfavorable finish.

Removal of scratches from stainless steel and non-ferrous metal

1. The deeper the scratch, the coarser the grit is usually to be used.

2. Get started sanding with all the coarsest grit. Machine must be set to "2" around the RPM pre-set dial. Move the sander more than the entire area on the scratch.
When the scratch is nearly invisible, begin operating with ever finer grits till requested finish has been achieved.

Achieving a polished mirror finish on stainless steel and non-ferrous metal

1. Begin having a coarse grit. Perform the surface until you may have a "universal scratch pattern".

2. Step by way of the numerous grit levels (grit 400, grit 600, grit 1,500) until you may have completed together with the finest grit.
NOTE: Only proceed for the next grit level when a universal scratch pattern has been achieved.

Go Back


Blog Search


There are currently no blog comments.